No Sin Mi Visa

This week’s DIY from Because I’m Addic­ted (http://becauseimaddicted.net/2012/03/diy-shark-tooth-necklace.html) is ins­pi­red by Givenchy’s fierce shark tooth necklace. You’ll need 28″ of chain, 1′ of wire, 1 clasp, pliers, wire cut­ters and a shark tooth. Mea­sure out a foot of wire and cut it with your wire cut­ters. Create a wire loop (http://www.beadaroo.com/techniques/view/wirewraploop) big enough for your chain by wrap­ping the wire tightly around the tip of your pliers seve­ral times. Hol­ding the wire loop against the back of the tooth, wrap the wire around the right side and then the left, alter­na­ting sides three times. Wrap the remai­ning wire around your wire loop and slip the chain through the loop. Add the clasp and you’re ready to wear your shark tooth necklace!

Thanks to Because I’m Addic­ted for the awe­some DIY!

DIY Shark Tooth Necklace')">